Hohmann & Barnard FLASHGUARDNA2860F Non-Asphaltic Fabric Flashing With Termite Shield, 60'

Highlights:

• Type: Non-Asphaltic
• Length: 60' Roll
• Width: 8"
• Material: Copper
• Mounting Type: Thru-Wall/Surface
• Load Capacity: 2 oz
• Termite Shield
• Use foundation flashing, door and window flashing
• Excellent for flashing pressure-treated and composite decks
• UV-resistant for up to 180 days
• Highly resistant to oils and will repel most chemicals
• Extremely tough, with excellent impact and tear resistance
• Maintains flexibility in extreme heat and cold weather environments
• Asphalt-free composition compatible with a wide variety of sealants
• It is formulated to be compatible with the most common EPA pressure treatment standards including ACQ
• Compatible with ACQ and other wood treatments
• Treated to isolate galvanized parts and protect against corrosion
• Provides dual-layered, self-sealing protection
• Lightweight, flexible and easy to work with
• Resists temperatures up to 275 degree F without separation
• Non-asphalt, non-corrosive and non-galvanic
• UV protection for life
• Installation: FLASH-GUARD NA should be installed between the foundation and the sill plate, ledger or other framing component
• Surfaces must be free from debris to avoid puncturing
• Install in large sections to avoid gaps and seams, lapping all joints a minimum of 6" to insure there are no gaps
• Edge flashing should extend 2" beyond the edge of the foundation and turned down at a 45 degree angle
• It is recommended that any and all penetrations are lapped and sealed using HB sealant
• Note: Use stainless steel or copper nails only